Short plug
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 328xi, 2010 BMW 328i, and 2009 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
Unlock slide (2) in bore holes (1) and pull out of housing.
Unlock tab (3), pull contact carrier (4) in direction of arrow out of housing.
Unlock and disconnect all plug connections of engine wiring harness section in electronics box.
ENGINE WIRING HARNESS - WORKING STEPS
| Work step | Note: |
|---|---|
| Unlock plug connections on control sensors and disconnect | |
| Unlock plug on alternator and disconnect | |
| Unlock plug connection on knock sensors and disconnect | |
| Unlock plug on crankshaft sensor and disconnect | |
| Unlock plug on starter motor and disconnect | |
| Remove REAR UNDERBODY PROTECTION | |
| Unlock plug connections on monitor sensors and disconnect | |
| Unlock plug on oil condition sensor and disconnect |
NOTE:
Check stored fault messages.
Now clear the fault memory.
Now clear the fault memory.