5147491 Removing and installing/replacing rear underbody protection

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 BMW 328i, 2011 BMW 323i, 2010 BMW 335i, 2010 BMW 328i, and 2010 BMW 323i. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Scalding hazard!
This work may only be carried out on an exhaust system which has cooled down.

Single-part underbody protection (except E90/E91/E92 AWD)

Release screws (1).

Pull underbody protection (2) in direction of arrow out of bracket (3).

Installation:

Ensure correct seating.

Centre underbody protection (2) and tighten down screws (1).

Fig 1: Removing Underbody Protection From Bracket

Courtesy of BMW OF NORTH AMERICA, INC.

Single-part underbody protection (E90/E91/E92 AWD)

Release screws (1).

Remove underbody protection (2) downwards.

Installation:

Ensure correct seating.

Centre underbody protection (2) and tighten down screws (1).

Fig 2: Identifying Screws And Underbody Protection

Courtesy of BMW OF NORTH AMERICA, INC.

Two-part underbody protection

Release screws (1).

Detach underbody protection (2) from bracket (3) and remove.

Installation:

Ensure correct seating.

Centre underbody protection (2) and tighten down screws (1).

Fig 3: Removing Underbody Protection From Bracket

Courtesy of BMW OF NORTH AMERICA, INC.