3441220 Removing and installing/renewing all parking brake shoes

Necessary preliminary tasks 

• Remove rear BRAKE DISC 

Lock adjuster unit (ASZE).

Actuate parking brake lever. Connect special tool 32 1 030 . Press stop (1) of adjusting spring back to such an extent that retaining hook (2) engages in stop (1).

Installation: 

Unlock adjuster unit (ASZE).

Lever out restraining hook (2) with a suitable screwdriver.

Restraining hook (2) must detach from stop (1) of adjusting spring.

Fig 1: Adjusting Spring Back To Retaining Hook Using Special Tool (32 1 030)

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect return spring (1) with brake spring pliers.

Installation: 

Return spring (1) must not be overelongated.

Check and if necessary replace return spring (1).

Pay attention to installation position of adjusting screw (2).

Apply a thin coat of grease to bush and screw threads.

Fig 2: Identifying Return Spring With Brake Spring Pliers

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect return spring (1) with brake spring pliers.

Installation: 

Return spring (1) must not be overelongated.

Check and if necessary replace return spring (1).

Fig 3: Identifying Return Spring

Courtesy of BMW OF NORTH AMERICA, INC.

Twist roll pins (1) 90° with special tool 34 4 000 and detach.

Remove brake pads (2).

Fig 4: Twisting Roll Pins 90° Using Special Tool (34 4 000)

Courtesy of BMW OF NORTH AMERICA, INC.

After installation 

• Adjusting PARKING BRAKE