3355000 Removing and installing/replacing rear anti-roll bar
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 BMW 328i, 2011 BMW 323i, 2010 BMW 335i, 2010 BMW 328i, and 2010 BMW 323i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
M3:
When installing the anti-roll bar, make sure the two rubber mount halves are correctly installed and correctly engaged on both sides (in the retaining bracket).
When installing the anti-roll bar, make sure the two rubber mount halves are correctly installed and correctly engaged on both sides (in the retaining bracket).
Necessary preliminary tasks
- Remove both REAR COIL SPRINGS
- Remove LEFT CONTROL ARM ON WHEEL CARRIER
- Remove both ANTI-ROLL BAR LINKS FROM ANTI-ROLL BAR
- Lower rear axle support See 3331503 LOWERING/RAISING REAR AXLE CARRIER (SPECIAL TOOL SWZ00-2040) or 3331503 LOWERING/RAISING REAR AXLE CARRIER (UNIVERSAL LIFTER)
NOTE:
To simplify the picture, anti-roll bar removal is shown on the removed rear axle.
Release screws (1).
Remove both RUBBER MOUNTS FROM ANTI-ROLL BAR .
Turn anti-roll bar (2) and remove sideways.
Installation:
Check both RUBBER MOUNTS FOR DAMAGE and replace if necessary.
Tightening torque 33 55 1AZ .
After installation
- Bleed BRAKING SYSTEM