3355021 Replacing both rubber mounts for anti-roll bar mounting
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 BMW 328i, 2011 BMW 323i, 2010 BMW 335i, 2010 BMW 328i, and 2010 BMW 323i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks
- Remove REAR WHEELS
- Remove fuel filler pipe
Release screws (1).
Tightening torque 33 55 1AZ .
Remove retaining bracket (2) and rubber mount (3).
Installation:
Keep retaining bracket (2), rubber mount (3) and anti-roll bar clean and free from oil and grease.
Clean rear anti-roll bar on both sides.
Position rubber mount on rear anti-roll bar.
Position retaining bracket on rubber mount.
Push rubber mount with retaining bracket on rear anti-roll bar to installation position.