3341153 Replacing wheel bearing (outside diameter 75 mm) on rear axle shaft

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 BMW 328i, 2011 BMW 323i, 2010 BMW 335i, 2010 BMW 328i, and 2010 BMW 323i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Remove drive flange of rear axle shaft See 3341005 REPLACING LEFT DRIVE FLANGE ON REAR AXLE SHAFT or 3341007 REPLACING RIGHT DRIVE FLANGE ON REAR AXLE SHAFT

Press retaining ring (1) together using pliers and remove.

Installation:

Install retaining ring (1).

Check seating of retaining ring (1), correct if necessary.

Fig 1: Identifying Retaining Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Pull out wheel bearing with special tools 33 4 041, 33 4 042, 33 4 031, 33 4 048 and 33 4 043.

Fig 2: Pulling Out Wheel Bearing Using Special Tools 33 4 041, 33 4 042, 33 4 031, 33 4 048 And 33 4 043

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Do not reuse old wheel bearing!

Installation:

Draw in new wheel bearing (1) with special tools 33 4 041, 33 4 042, 33 4 049, 33 4 047 and 33 4 043.

Fig 3: Installing Wheel Bearing Using Special Tools 33 4 041, 33 4 042, 33 4 049, 33 4 047 And 33 4 043

Courtesy of BMW OF NORTH AMERICA, INC.

After installation

Adjusting PARKING BRAKE