3200... Moving vehicle into design position
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 BMW 328i, 2011 BMW 323i, 2010 BMW 335i, 2010 BMW 328i, and 2010 BMW 323i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks
- Move VEHICLE INTO NORMAL POSITION
- Version with air spring system:
- Remove ignition key
- If necessary, pull fuse for air supply system control unit
- Add/distribute weights in area of spring struts until the vehicle ride height is within the tolerance (refer to Technical Data
See REAR AXLE - RIDE HEIGHT E90
or FRONT AXLE - RIDE HEIGHT
).
Measure ride-level height of vehicle. See 3133095 MEASURING RIDE-LEVEL HEIGHT OF VEHICLE