Remove starter motor

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2011 BMW 323i, 2010 BMW 328xi, and 2010 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

Release nut (1).

Remove cable lug (2).

Fig 1: Identifying Starter Motor Nut And Cable Lug

Courtesy of BMW OF NORTH AMERICA, INC.

CAUTION: Do not turn cable lug (2) while tightening down - risk of short circuit to starter motor housing.

Tightening torque, 12 41 3AZ .

Release screws (1).

Fig 2: Identifying Starter Motor Housing Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Remove solenoid switch (1) and spring (2).

Unhook pin (3).

Installation:

Check pin (3) for wear and apply grease.

Fig 3: Identifying Solenoid Switch, Spring And Pin

Courtesy of BMW OF NORTH AMERICA, INC.