62 30 010 Removing and installing/renewing head-up display
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION)
.
IMPORTANT:
Comply with notes and instructions on HANDLING OPTICAL FIBRES
.
Risk of damage!
Do not scratch lens of head-up display.
Necessary preliminary work:
- Remove INSTRUMENT PANEL TRIM
Release screw (1) on carrier housing (2) at bottom.
Tightening torque 62 30 1AZ .
Remove sound insulation (1) from head-up display (4).
Disconnect plug connections (2).
Release screws (3).
Tightening torque 62 30 1AZ .
Carefully feed out head-up display (4) in upward direction.
Installation note:
Clean lens of head-up display.
Adjust HEAD-UP DISPLAY .
Replacement:
Carry out VEHICLE PROGRAMMING/ENCODING .