65 11 075 Removing and installing/replacing DVD changer

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with NOTES on protection against electrostatic damage (ESD protection).

IMPORTANT: Comply with instructions on HANDLING OPTICAL FIBRES .

Necessary preliminary tasks:

Disconnect BATTERY EARTH CABLE .
Remove DECORATIVE STRIP ON STORAGE COMPARTMENT/DVD CHANGER INSTRUMENT PANEL

NOTE: Affects all vehicles from series introduction to 09/2009 with DVD changer (SA696)!

When a new DVD changer (2) is being replaced (as of 09/09 ), conversion to ISTA/P must be carried out.

If the old DVD changer (1) is installed (up to 09/09 ), this conversion to ISTA/P must not be carried out.

The old DVD changer (1) and the DVD changer (2) have an external difference in that the Load and Eject buttons are swapped round.

Fig 1: Identifying DVD Changer

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip trims (1) with a suitable tool and release screws behind.

Pull DVD changer (2) out of guide.

Unlock associated plug connection (3) and disconnect.

Remove DVD changer (2).

Fig 2: Identifying Trims, DVD Changer And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out VEHICLE PROGRAMMING/CODING .