66 53 020 Removing and installing (replacing) reversing camera
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION)
.
Necessary preliminary work:
- Remove CENTER TRUNK LID TRIM STRIP
Unlock latch mechanisms (2) and lever reversing camera holder (3) out of center trunk lid trim strip (4).
Feed reversing camera (1) out of camera holder (3).
Replacement:
Remove protective film from lens of reversing camera (1).
Fig 1: Identifying Latch Mechanisms And Lever Reversing Camera Holder Out Of Center Trunk Lid Trim Strip
After installation:
- Calibrate REVERSING CAMERA
Replacement:
Carry out VEHICLE PROGRAMMING/ENCODING