52 17 392 Removing and installing/replacing front left or right crash-active head restraint (production date 07/2012 through model year 2015)

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: This removing/installing/replacing procedure applies to "Comfort" seat version.

WARNING:

Comply with SAFETY REGULATIONS for handling components with gas generators.

Incorrect handling may result in triggering of the crash-active headrest and thereby cause injury.

Switch off the ignition!

Necessary preliminary work:

Disconnect BATTERY NEGATIVE CABLE
Remove REAR PANEL

Starting situation:

Head restraint is in the crash position after activation.

A triggered head restraint can be recognized by the padded section which has moved upwards.

Fig 1: Identifying Activated Head Restraint

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock PLUG CONNECTION (1) and disconnect.

For easier access to the retaining clips (next operation):

Move head restraints downwards or
detach backrest cover (2) in the upper area.

Fig 2: Detaching Backrest Cover In Upper Area
Courtesy of BMW OF NORTH AMERICA, INC.

Lever out retaining clips (1)

Installation note:

Make sure the retaining clips are correctly seated.

Fig 3: Locating Retaining Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Lift out head restraint.

Fig 4: Lifting Head Restraint

Courtesy of BMW OF NORTH AMERICA, INC.