54 12 136 Removing and installing/replacing sliding trim for glass slide/tilt sunroof

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Remove GLASS SLIDE/TILT SUNROOF COVER
Close sliding trim completely

Release screws (1).

Tightening torque 54 12 3AZ .

Remove sliding strips from guide rail.

Installation note:

Make sure rubber lugs are correctly seated on sliding strips.

Remove sliding trim towards front.

Fig 1: Identifying Glass Slide/Tilt Sunroof Cover Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Correctly insert front sliding strips into driver (drive cable).

Fig 2: Identifying Front Sliding Strips

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

If sliding trim is difficult to move, apply a light coat of Renolit RHF1 (manufactured by Fuchs) to guide duct.