51 22 330 Removing and installing/replacing window cavity cover strip on inside rear door

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: The "INSTRUCTIONS ON FITTING WINDOW GUIDE SEALS " serve as the basis for this repair instruction and must be observed without fail.

Necessary preliminary tasks:

Remove REAR DOOR TRIM PANEL

Pull front window cavity cover strip (1) off rear door.

Installation note:

Moisten window cavity cover strip (1) prior to fitting with approved lubricant, see 3. AUXILIARY MATERIALS AND TOOLS .

Fig 1: Pulling Front Window Cavity Cover Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Pull rear window cavity cover strip (1) off rear door.

Fig 2: Pulling Rear Window Cavity Cover Strip

Courtesy of BMW OF NORTH AMERICA, INC.