64 11 262 Removing and installing/replacing auxiliary water pump
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Danger of scalding!
Only perform this work after engine has cooled down.
Recycling:
Coolant emerges when coolant lines are detached. Have a suitable collecting container ready.
Catch and dispose of emerging coolant.
Observe country-specific waste disposal regulations.
Necessary preliminary work:
- Remove FRONT WHEEL ARCH COVER
- Disconnect COOLANT HOSES .
Unlock spring clamps (1) with special tool 17 2 050 .
Pull off coolant hoses (2) from auxiliary water pump (3).
Unlock associated plug connection and disconnect.
Pull off auxiliary water pump (3) from bracket (4).
Installation note:
Make sure auxiliary water pump (3) is seated correctly in bracket (4).
After installation: