24 00 043 Installing replacement transmission (GA6HP26Z) (N63)
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2014 BMW Alpina B7L, 2014 BMW Alpina B7, and 2013 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.
Drain automatic transmission oil at oil drain plug.
Tightening torque 24 11 2AZ .
IMPORTANT:
After completion of work, program control unit for transmission.
Recycling:
Catch and dispose of escaping transmission oil.
Observe country-specific waste-disposal regulations.
IMPORTANT:
- Before installing replacement transmission, always flush TRANSMISSION OIL COOLER TOGETHER WITH LINES .
- After completion of work, CHECK TRANSMISSION OIL LEVEL .
- Use only approved TRANSMISSION OIL
Failure to comply with this requirement will result in serious damage to the automatic transmission.
Replacement transmissions come filled with transmission oil
Necessary preliminary tasks:
- Remove AUTOMATIC TRANSMISSION
Modify gearshift lever (1).
Tightening torque 24 51 1AZ .
Modify clip (2) for cable.
Modify transportation retainers.
Convert all cable holders.
Convert all seal plugs.
Modify protective cap on output shaft.
IMPORTANT:
After removing transportation lock, secure torque converter against slipping out.
Transmission identification:
- On type plate