61 35 243 Removing and installing (replacing) Smart Opener top sensor line (non-contact rear lid opening)
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .
Necessary preliminary work:
- Remove COVER ON REAR BUMPER PANEL .
IMPORTANT:
Risk of damage, do not kink sensor line!
Unlock plug connection (1) and disconnect.
Feed out connecting line from holder.
Release sensor line (2) at clips (3) and remove.
Installation note:
Make sure plug connection (1) and sensor line (2) are correctly seated.
Make sure connecting line is correctly laid.
Clips (3) must not be missing or damaged.