65 52 023 Replacing Panel For On-Board Monitor (Control Panel, Widescreen)

WARNING: This page is about a different car, the 2003 BMW X5, 2002 BMW X5, 2001 BMW X5, and 2000 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection). Refer to 61 35 ... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Necessary preliminary tasks:

Remove complete on-board monitor (widescreen), refer to 65 52 013 REMOVING AND INSTALLING COMPLETE ONBOARD MONITOR (WIDESCREEN)

Release screws (1).

Fig 1: Removing Upper Housing Section

G03253902

Courtesy of BMW OF NORTH AMERICA, INC.

Remove upper housing section (2) in direction of arrow.

Raise locks (1) in direction of arrow.

Fig 2: Detaching Ribbon Cables

G03253903

Courtesy of BMW OF NORTH AMERICA, INC.

Detach ribbon cables (2) and feed out at catches (3).

Installation:

Make sure ribbon cables are correctly seated.

NOTE: Carefully feed out ribbon cables when removing panel for onboard monitor (control panel).

Release screws (1).

Fig 3: Removing Panel For Onboard Monitor

G03253904

Courtesy of BMW OF NORTH AMERICA, INC.

Remove panel for on-board monitor (control panel) in direction of arrow.