61 62 060 Removing and installing / replacing rear window wiper motor

WARNING: This page is about a different car, the 2003 BMW X5, 2002 BMW X5, 2001 BMW X5, and 2000 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Remove panel for rear lid upper section at bottom. Refer to 51 49 050 REMOVING AND INSTALLING/REPLACING LOWER TRIM FOR REAR LID UPPER SECTION .

Remove wiper arm for rear wiper. Refer to 61 62 030 REPLACING WIPER ARM FOR REAR WINDOW WIPER .

NOTE: Secure rear window wiper motor against falling out.

Disconnect plug connection (1) and release screws (2).

Fig 1: Removing Rear Window Wiper Motor

Courtesy of BMW OF NORTH AMERICA, INC.

Remove rear window wiper motor (3).

Installation:

Insert screws (2) and tighten until hand-tight.

Center rear window wiper motor (3) and tighten down screws (2).

Observe tightening torque, 61 62 1AZ. Refer to BODY EQUIPMENT - TIGHTENING TORQUES .

Installation:

Replace rubber grommet (1).

Fig 2: Replacing Rubber Grommet

Courtesy of BMW OF NORTH AMERICA, INC.

Note installation position of rubber grommet (1) (marking must be in horizontal position).