66 20 534 Removing and installing/replacing rear left ultrasonic transducer (Park Distance Control)

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove rear bumper trim . See 51 12 156 REMOVING AND INSTALLING REAR BUMPER TRIM .

Unlock retaining tabs (1) in direction of arrow and pull ultrasonic transducer (2) out of holder (3).

Fig 1: Pulling Ultrasonic Transducer Out Of Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Retaining hooks (1) of ultrasonic transducer (2) must engage exactly in mountings (3).

Fig 2: Identifying Retaining Hooks Of Ultrasonic Transducer And Mountings

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure rubber ring (1) is correctly seated on ultrasonic transducer (2).

Fig 3: Identifying Rubber Ring On Ultrasonic Transducer

Courtesy of BMW OF NORTH AMERICA, INC.