65 11 080 Removing and installing/replacing radio receiver
WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on protection against electrostatic damage (ESD protection)
. See61 35 ... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE)
.
Necessary preliminary tasks:
- Disconnect battery negative lead . See 61 20 900 DISCONNECTING AND CONNECTING BATTERY NEGATIVE LEAD .
- Remove operator unit for heater/air conditioner . See 64 11 377 REMOVING AND INSTALLING/REPLACING HEATER/AIR CONDITIONER OPERATOR UNIT (VERSION WITHOUT CCC/ASK) .
NOTE:
Comply with notes and instructions on handling optical waveguides
. See 61 00 ... NOTES ON HANDLING OPTICAL FIBERS
.
Release screws (1).
Pull back radio receiver (2) slightly.
Disconnect associated plug connections and remove radio receiver (2).
Installation:
Make sure the rear guide pin of the radio receiver (2) is correctly seated in the associated mounting.
Replacement:
Carry out programming/coding .