65 77 740 Removing and installing (replacing) left front door sensor
WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on protection against electrostatic damage (ESD protection)
. See61 35 ... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE)
.
WARNING:
Note airbag safety instructions!
Incorrect handling can activate airbag and cause injury. See 72 00 ... SAFETY REGULATIONS FOR HANDLING COMPONENTS WITH GAS GENERATORS .
Incorrect handling can activate airbag and cause injury. See 72 00 ... SAFETY REGULATIONS FOR HANDLING COMPONENTS WITH GAS GENERATORS .
Necessary preliminary tasks:
- Detach sound insulation in work area. See 51 48 060 REMOVING AND INSTALLING/REPLACING SOUND INSULATION IN LEFT OR RIGHT FRONT DOOR .
Unfasten plug connection (1) and disconnect.
Release screw (2).
Tightening torque 65 77 7AZ , see 65 77 AIRBAG TRIGGERING CONTROL .
Remove sensor with pin (3) from door panel fit (4) towards rear.
Installation:
Make sure fit (3) is correctly seated.