51 24 004 Adjusting rear lid lock
WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
Prerequisite:
Rear lid must be correctly adjusted to fit; if necessary, adjust rear lid . See 41 62 014 ADJUSTING REAR LID .
For ideal adjustment, refer to Body gap dimensions .
NOTE:
The operation is shown on the left side; proceed in the same way for the right side.
Necessary preliminary tasks:
- Remove trim for support tube .
Slacken screws (1) until striker (3) can be moved.
Slide striker (3) in direction of arrow.
Tighten down screws (1).
Tightening torque 51 24 4AZ, see 51 24 REAR LID LOCKS .
Check alignment of rear lid and striker, readjust if necessary.
If necessary, remove shims (2) or insert additional.