51 13 116 Removing and installing cowl panel cover

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove windscreen wiper arm on left/right. See 61 61 100 REMOVING AND INSTALLING/REPLACING BOTH WINDSCREEN WIPER ARMS .
Remove microfilter housing . See MICROFILTER .

IMPORTANT: Danger of water ingress via fan into vehicle interior if cowl panel cover and sealing strip are not correctly fitted.

Pull off hose (1).

Disconnect plug connections (2).

Detach mucket (3).

Take off cover (4).

Installation:

Make sure cover (4) is correctly seated.

Fig 1: Identifying Hose And Plug Connections

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Sealing strip (1) must be fitted (water ingress)

If necessary, retrofit sealing strip (1).

Fig 2: Identifying Sealing Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure grommets (1) are correctly seated on wiper pivots.

Grommets (1) for wiper pivots must not be damaged.

If necessary, replace grommets (1).

Fig 3: Identifying Grommets

Courtesy of BMW OF NORTH AMERICA, INC.

E90/E91 only:

Installation:

Cowl panel cover (1) must be correctly guided on right and left under windscreen cover (2).

Fig 4: Identifying Cowl Panel Cover And Under Windscreen Cover

Courtesy of BMW OF NORTH AMERICA, INC.

E92/E93 only:

Installation:

Cowl panel cover (1) must be correctly guided on right and left under windscreen cover (2).

Fig 5: Identifying Cowl Panel Cover And Under Windscreen Cover

Courtesy of BMW OF NORTH AMERICA, INC.