61 61 100 Removing and installing/replacing both windscreen wiper arms

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

61 6 210

NOTE:

See GENERAL ELECTRICAL SYSTEM - SPECIAL TOOLS .

Take off cap.

Fig 1: Removing Windscreen Wiper Arms Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten nut. Tightening torque, see 61 61 11AZ in 61 61 WINDSCREEN WIPERS .

Fig 2: Locating Windscreen Wiper Arms Nut

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of breakage!
Do not bend windscreen wiper arm when removing.

Detach windshield wiper arm with special tool 61 6 210 .

Fig 3: Identifying Special Tool On Windshield Wiper Arm

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Windscreen wiper motor must be in its rest position.

Observe adjustment dimensions .

Adjust position of relevant windscreen wiper arm (measured between windscreen wiper blade and trim panel on cowl panel at height of windscreen wiper arm locator).

Tighten down windscreen wiper arm and check adjustment dimensions of respective windscreen wiper arm again.

Check and if necessary adjust contact angle .