51 12 ... Replacing trim on rear bumper (M Technic aerodynamic kit)
WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 00 9 317
See MAINTENANCE AND GENERAL INFORMATION - SPECIAL TOOLS .
Necessary preliminary tasks:
- Remove rear bumper trim
- Remove bottom middle trim on rear bumper
Carefully heat trim (1) with hot air blower and detach with special tool 00 9 317 from bumper (2).
Installation:
Minimum object temperature of trim and bumper ≥ 18°C.
If this temperature is not achieved, the components must be preheated.
For cleaning, use a fluff-free disposable cloth or a clean cleaning cloth.
Clean adhesive area of bumper with spirit.
Air drying time at least 1 minute.
Installation:
Trim (1) is positioned over guides (2) on bumper.
Remove liner from trim (1).
Press down trim (1) firmly with back of your hands over entire surface, especially the ends.