51 16 000 Removing and installing or replacing mirror on left or right front door (convertible)

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Unclip trim (1) from retaining clip (2) in inward direction. Slide trim (1) upwards slightly out of guide (3) and remove.

Fig 1: Removing Trim

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: On version with speaker, trim (1) can remain hanging over door trim panel.

Installation: Retaining clip (2) must be fitted on door.

Installation: Following parts of trim must not be damaged or missing:

Sound insulation
Retaining lug
Guide

Fig 2: Identifying Sound Insulation, Retaining Lug And Guide

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage! Secure mirror against falling down.

Disconnect plug connection (1). Fold seal (2) to one side slightly and release screws (3). Tightening torque 51 16 1AZ, see 51 16 MIRRORS, FINISHERS, ASHTRAYS, CONSOLES .

Fig 3: Identifying Plug Connection And Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: Rubber grommet for plug connection (1) must be correctly seated on door. Seal (2) must be correctly seated on door trim panel and door.

Remove mirror (1) outwards. Installation: Check function.

Fig 4: Removing Mirror Outwards

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Modify mirror glass , replace if necessary.
Modify cover cap , replace if necessary.
Modify mirror base cover, replace if necessary