51 23 110 Removing and installing/replacing left hood/bonnet lock

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Unclip coupling (1) from side panel.

Lever out cover (2) at coupling (1).

Lever cable (3) out of coupling (1).

NOTE: The operation "Disconnect cable for hood/bonnet locks" ends here.

Fig 1: Identifying Cable And Coupling

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Fig 2: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Carefully pull bumper (2) forwards and feed out hood/bonnet lock (3) with cable.

Tightening torque 51 23 2AZ , see 51 23 HOOD/BONNET LOCKS .

Fig 3: Identifying Bumper And Hood/Bonnet Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Disengage cable (1) from hood/bonnet lock (2).

When replacing cable for hood/bonnet locks:

Feed cable (1) out of front wall.

Fig 4: Identifying Cable And Hood/Bonnet Lock

Courtesy of BMW OF NORTH AMERICA, INC.