51 47 440 Removing and installing/replacing rear carpet on seat pan (convertible/coupe)
WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove left/right front seat . See SEATS - REPAIR (CONVERTIBLE/COUPE) .
- Remove storage compartment
- Remove handbrake lever . See 34 41 000 REMOVING AND INSTALLING / REPLACING HANDBRAKE LEVER .
- Remove rear side trim left/right.
- Remove inside entrance cover strip
Version with central bass speaker:
- Remove central bass speaker trim on left/right. See 65 12 050 REMOVING AND INSTALLING/REPLACING LEFT OR RIGHT CENTRAL BASS SPEAKER (UNDER FRONT SEAT) .
E92 only:
Lever out cap (1).
Release bolt (2).
Tightening torque 72 11 5AZ, see 72 11 SEAT BELTS .
Feed out belt and slide bar.
Installation:
Make sure slide bar and grommet are correctly positioned.
Check that spacer bushing (3) and rubber ring (4) are in correct position.
Remove holder (1).
Pull back cable (2) with cable holder (3).
Feed out carpet (4).
Installation:
Make sure openings for air duct and attachment points are correctly positioned.