51 47 161 Removing and installing / replacing right luggage compartment wheel arch trim

Necessary preliminary tasks: 

• Remove trim on rear apron  
• Remove flap in luggage compartment panel  

  Version with through-loading system: 

• Fold down backrest for right rear seat

Specification with pocket holder: 

Pull expander rivets (1) out of pocket holder (2) and remove pocket holder (2).

Fig 1: Identifying Expander Rivets And Pocket Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Release clips (1).

Release screw (2) and remove cover (3).

Feed out luggage compartment wheel arch trim (4) in direction of arrow.

Fig 2: Identifying Screw And Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Installation in version without through-loading system only: 

Installation: 

To install luggage compartment wheel arch trim, proceed as follows:

• Remove rear seat  . See SEATS - REPAIR .
• Unscrew screws (1).
• Press backrest from luggage compartment in direction of vehicle interior and feed luggage compartment wheel arch trim between wheel arch and backrest

Tightening torque 52 24 01AZ  , see 52 24 REAR SEAT (NORMAL), MANUAL .

Fig 3: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: 

If necessary, release retainers (1) on back of luggage compartment wheel arch trim (2) and remove securing net (3).

Fig 4: Identifying Retainers, Luggage Compartment Wheel Arch Trim And Securing Net

Courtesy of BMW OF NORTH AMERICA, INC.