51 46 050 Removing and installing/replacing top trim on rear apron

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove luggage compartment floor trim (luggage compartment mat)

Detach seal (1) in covered area of trim (4).

Lever out protective caps (2) and release screws underneath.

Release expansion rivets (3).

Lever out trim (4) inwards/upwards.

Installation:

If necessary, replace damaged protective caps (2) and expander rivets (3).

Fig 1: Identifying Protective Caps And Expander Rivets

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Lift off cover (1).

If necessary, feed out universal holders (2).

Fig 2: Identifying Universal Holders

Courtesy of BMW OF NORTH AMERICA, INC.