25 11 211 Replacing shift arm for shift-lever mount

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove shift lever

Lever support bearing (1) out of fixture.

Fig 1: Levering Support Bearing

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Install support bearing (1) with arrow (2) facing upwards in holder.

Fig 2: Installing Support Bearing

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock bearing pin (1) in direction of arrow and remove.

Installation:

Grease bearing pin.

Fig 3: Unlocking Bearing Pin

Courtesy of BMW OF NORTH AMERICA, INC.

Remove shift arm.

Detach support bearing (1) from shift arm.

Installation:

Grease bearing journal.

Attach support bearing (1) with opening (3) towards rear on shift arm.

Fig 4: Identifying Support Bearing With Shift Arm

Courtesy of BMW OF NORTH AMERICA, INC.

Replace bearing bush if damaged.

Press out bearing bush.

Coat new bearing bush with Circolight and then press into shift arm until side flanges of bearing bush protrude uniformly.

Fig 5: Identifying Bearing Bush

Courtesy of BMW OF NORTH AMERICA, INC.