61 61 270 Removing and installing/replacing bracket for windscreen wiper system complete with motor

WARNING: This page is about a different car, the 2010 BMW M3, 2009 BMW M3, and 2008 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove both wiper arms
Remove lower section of microfilter housing . See 64 31 062 REMOVING AND INSTALLING/REPLACING LEFT LOWER MICROFILTER HOUSING SECTION and 64 31 063 REMOVING AND INSTALLING/REPLACING RIGHT LOWER MICROFILTER HOUSING SECTION .
Remove cowl panel cover .
Remove both tension struts from spring strut dome.

Release screws (2) from left heater bulkhead (3).

Remove left heater bulkhead (3) towards top.

Unclip cable (1) for wiper motor from holder.

Release screws (5) for wiper bracket (4).

Tightening torque, see 61 61 11AZ in 61 61 WINDSCREEN WIPERS .

Remove wiper bracket (4) upwards.

Disconnect plug for wiper motor.

Fig 1: Identifying Screws, Heater Bulkhead, Cable And Wiper Bracket

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Rubber mount (1) and rubber guide (3) must not be missing.

Rubber guide (3) must be correctly seated in guide (2).

Fig 2: Identifying Rubber Mount And Rubber Guide

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Before fitting the wiper arms, allow the windscreen wiper motor to run into the rest position.

To ensure that the windscreen wiper system functions properly, check/adjust the contact angle of the wiper arms to the windscreen.