51 43 255 Removing and installing/replacing trim for rear left or right roof pillar (front)

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Follow SAFETY INSTRUCTIONS for working on cars with airbag systems.

IMPORTANT: Do not use any sharp-edged tools to remove trim (risk of damage to head airbag).

Necessary preliminary tasks:

Remove TRIM FOR REAR ROOF PILLAR (REAR)

Detach expansion rivets (1) and clips (2) from trim (3).

Pull out trim (3) inwards/upwards.

Installation:

If necessary, replace faulty clips (2) or expansion rivets (1).

Fig 1: Removing Trim For Rear Roof Pillar (Front)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Following parts of trim (2) must not be damaged or missing:

Insulating mat

Fig 2: Identifying Trim And Insulating Mat
Courtesy of BMW OF NORTH AMERICA, INC.