51 43 251 Removing and installing/replacing trim for rear left or right roof pillar (rear)

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Follow SAFETY INSTRUCTIONS for working on cars with airbag systems.

IMPORTANT: Do not use any sharp-edged tools to remove trim (risk of damage to head airbag).

Lever out airbag emblem (1) and release screw underneath.

Installation:

Tightening torque: see 1AZ in 51 43 SIDE TRIM PANEL WITH ARMRESTS

Unclip clip (3) and clips (4) of trim (2) and pull out trim (2) inwards and upwards.

Fig 1: Removing Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Retainer (1) on trim (2) must not be damaged or missing.

Fig 2: Identifying Retainer On Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Following parts of trim (4) must not be damaged or missing:

Clip
Guide
Clips

Fig 3: Identifying Trim, Clips And Guide
Courtesy of BMW OF NORTH AMERICA, INC.