51 43 070 Removing and installing/replacing side trim panel, footwell, on A-pillar, left

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove FRONT DOOR SILL TRIM STRIP .

Release door mucket (1) in area of footwell side trim panel on A-pillar on left (2).

Unscrew bolt (3).

Remove engine hood actuator lever (4) from footwell side trim panel on A-pillar on left (2).

Fig 1: Removing Engine Hood Actuator Lever

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew bolt (1).

Unclip footwell side trim panel on A-pillar on left (3) in direction of arrow from retaining point (2) and remove.

Fig 2: Removing Footwell Side Trim Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, lever out clip (1) remaining in bore.

If necessary, replace faulty clip (1).

Place footwell side trim panel on A-pillar on left (2) preinstalled with clip (1) on associated bore and clip into place.

Replacement:

Press catches and remove switch for unlocking rear lid (3).

Fig 3: Removing Switch For Unlocking Rear Lid

Courtesy of BMW OF NORTH AMERICA, INC.