51 47 000 Removing and installing/replacing front (inside) left or right entrance cover strip
WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
Disengage retaining lugs (5) of front entrance cover strip (2) from both adjoining panels.
IMPORTANT:
Carefully lever out front entrance cover strip (2).
Lever out front entrance cover strip (2) at front retaining points (3).
Pull back front entrance cover strip (2) and feed out of rear retaining points (1).
Installation:
Position front entrance cover strip (2) preinstalled with clips (4) on associated bores and clip into place.
Installation:
Rails of front entrance cover strip (2) must not be damaged.
Retaining lugs (3) of front entrance cover strip (2) must not be damaged.
If necessary, lever out remaining clips (1) in floor panel.
If necessary, replace faulty clips (1).
Slide clips (1) into rails of front entrance cover strip (2).