51 22 180 Removing and installing/replacing cover on outside handle

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If replacing version with Comfort Access/CA:
In order to avoid Comfort Access malfunction, use only original BMW paints on the cover with electrically non-conducting primer.

Necessary preliminary tasks:

Remove OUTSIDE HANDLE

Remove trim (2).

Fig 1: Removing Trim

G05503775

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Protect bore (1) against scratching (risk of corrosion).

Release screw (2).

Installation:

Press cover (3) slightly towards rear when screwing down (gap).

Tightening torque: see 8AZ in 51 22 REAR DOOR LOCKS

Fig 2: Identifying Cover

G05503782

Courtesy of BMW OF NORTH AMERICA, INC.

Remove stop pad (1).

Fig 3: Removing Stop Pad

G04760980

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Press mounting (2) back, lever out cover (3) at rear and remove in direction of arrow.

Tightening torque: see 7AZ in 51 22 REAR DOOR LOCKS

Fig 4: Removing Cover

G05503784

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Following parts of cover on outside handle (5) must not be damaged or missing:

Thread
Bridges
Bridges
Screw surface

Fig 5: Identifying Outside Handle, Thread And Bridges
Courtesy of BMW OF NORTH AMERICA, INC.