51 22 170 Removing and installing / replacing outer door handle on left or right rear door

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If replacing version with Comfort Access/CA:
In order to avoid Comfort Access malfunction, use only original BMW paints on the outside handle with electrically non-conducting primer.

Removal:

NOTE: Installation is described separately from removal.

Unclip seal (1) in direction of arrow.

Fig 1: Unclipping Seal

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Protect bore (1) against scratching (risk of corrosion).

IMPORTANT: If the screw is not correctly secured, the lock mechanism can jump back and the sound insulation must be removed.

Pull outside handle (2) outwards/upwards until screw (3) is accessible and hold.

Using special tool 51 2 220 , screw down screw (3) in counterclockwise direction and thereby secure outside handle (2).

Tightening torque: see 5AZ in 51 22 REAR DOOR LOCKS

Fig 2: Pulling Outside Handle Outwards/Upwards

Courtesy of BMW OF NORTH AMERICA, INC.

First pull off outer door handle (1) in area (A) from rear lock actuation (2).

Then pull outer door handle (1) in area (B) off of front lock actuation (3) in direction of arrow.

Fig 3: Pulling Off Outside Handle From Rear Lock Actuator

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Following parts on outside handle (4) must not be damaged or missing:

Rear mounting
Front mounting
Felt strip (if available for refitting/replacement no longer required)

Fig 4: Identifying Outside Handle, Rear Mounting, Front Mounting And Felt Strip
Courtesy of BMW OF NORTH AMERICA, INC.

Stop pad (1) must be fitted.

Insert outside handle (4) with bore (3) correctly in mounting (2).

Engage mounting (5) of outside handle (4) correctly in lock actuator (6).

Fig 5: Identifying Stop Pad, Outside Handle And Mounting

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Protect bore (1) against scratching/damaged paintwork (risk of corrosion).

IMPORTANT: If the screw is not correctly secured, the lock mechanism can jump back and the sound insulation must be removed.

Grip outside handle (2) and, using special tool 51 2 220 , screw down screw (3) in clockwise direction.

Tightening torque: see 5AZ in 51 22 REAR DOOR LOCKS

Carry out function check only with door open.

Fig 6: Gripping Outside Handle

Courtesy of BMW OF NORTH AMERICA, INC.