54 10 070 Removing and installing/replacing slider set for floating roofliner

WARNING: This page is about a different car, the 2010 BMW 535xi, 2009 BMW 535xi, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Unclip end stops (1) on left and right from guide channel.

Installation:

Engage end stops at front and clip into place by applying pressure.

Fig 1: Unclipping End Stops On Left And Right From Guide Channel

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully unclip slide block (1) on left and right (risk of damage).

Pull driver for rear floating roofliner (2) and slider set (3) towards rear out of guide.

Fig 2: Pulling Driver For Rear Floating Roofliner And Slider Set Towards Rear Out Of Guide

Courtesy of BMW OF NORTH AMERICA, INC.

Disengage rocker arm (1) from driver for rear floating roofliner (2).

Fig 3: Disengaging Rocker Arm From Driver For Rear Floating Roofliner

Courtesy of BMW OF NORTH AMERICA, INC.

Remove rocker arm (1) from rail and replace if necessary.

Fig 4: Removing Rocker Arm From Rail

Courtesy of BMW OF NORTH AMERICA, INC.