51 16 211 Removing and installing/replacing finisher for storage tray
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove KNOB FOR CONTROLLER
- Remove BUTTON UNIT
Version with manual transmission:
- Remove GAITER for gear lever
Version with automatic transmission or SMG:
- Remove finisher for preselector lever. See TRIM FOR PRESELECTOR LEVER (UP TO 03/2007) or TRIM FOR PRESELECTOR LEVER (FROM 03/2007) .
If necessary, remove ashtray insert.
Release screws (1).
Open center console cover.
Press release button for center console cover and release trim (2) from catches (4).
Feed trim (2) towards top/rear out of storage compartment (3).
If necessary, disconnect plug connections on insert at front.
Security version:
Disconnect plug connection on intercom system switch.
Installation:
Following parts of trim (4) must not be damaged or missing:
- Front insert
- Retaining lugs
- Pins or spring clips
Replacement:
Remove FRONT INSERT (1) .
Replacement with Security version:
Remove intercom system switch.