35 11 000 Removing and installing complete bearing block for foot pedal
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove pedal trim . See REMOVING AND INSTALLING/REPLACING PANEL FOR PEDALS .
- Vehicles with electric steering column:
- Remove electric steering column drive . See REMOVING AND INSTALLING/REPLACING DRIVE UNIT FOR ELECTRIC STEERING COLUMN ADJUSTMENT .
- Vehicles with manual transmission:
- Remove clutch pedal . See REMOVING AND INSTALLING / REPLACING CLUTCH PEDAL .
- Remove clutch master cylinder . See REMOVING AND INSTALLING/REPLACING CLUTCH MASTER CYLINDER .
IMPORTANT:
After completion of work, carry out function check.
Unfasten plug connection (1).
Remove locking clip (2) and disengage and pull out locking pin.
Release nuts (3) and remove bearing block.
Installation:
Replace self-locking nuts.
Tightening torque 35 11 1AZ.