51 22 180 Removing and installing/replacing cover on outside handle

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If replacing version with Comfort Access/CA:
In order to avoid Comfort Access malfunction, use only original BMW paints on the cover with electrically non-conducting primer.
New part (from 09/2005) is provided with electrically non-conducting primer.

Necessary preliminary tasks:

Remove outside handle

Remove trim (2).

Fig 1: Identifying Trim

G05477699

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Protect bore (1) against scratching (risk of corrosion).

Release screw (2).

Installation:

Press cover (3) slightly towards rear when screwing down (gap).

Tightening torque 51 22 8AZ . See 22 REAR DOOR LOCKS, HANDLE .

Fig 2: Identifying Cover And Screw

G05477706

Courtesy of BMW OF NORTH AMERICA, INC.

Remove stop pad (1).

Fig 3: Identifying Stop Pad

G05477657

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Press mounting (2) back, lever out cover (3) at rear and remove in direction of arrow.

Tightening torque 51 22 7AZ . See 22 REAR DOOR LOCKS, HANDLE .

Fig 4: Identifying Screw And Cover

G05477708

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Following parts of cover on outside handle (5) must not be damaged or missing:

Thread
Bridges
Bridges
Screw surface

Fig 5: Identifying Outside Handle Parts
Courtesy of BMW OF NORTH AMERICA, INC.