51 16 211 Removing and installing/replacing finisher for storage tray
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove knob for controller . See 61 31 192 REPLACING KNOB FOR CONTROLLER .
- Remove button unit . See 61 31 193 REMOVING AND INSTALLING/REPLACING BUTTON UNIT (FOR ON-BOARD MONITOR) .
Version with manual transmission:
- Remove gaiter for gear lever. See 25 11 081 REPLACING GAITER (SHIFT LEVER COVER) FOR SHIFT LEVER .
Version with automatic transmission or SMG:
- Remove finisher for preselector lever . See 51 16 210 Removing and installing/replacing trim for preselector lever .
If necessary, remove ashtray insert.
Release screws (1).
Open center console cover.
Press release button for center console cover and release trim (2) from catches (4).
Feed trim (2) towards top/rear out of storage compartment (3).
If necessary, disconnect plug connections on insert at front.
Security version:
Disconnect plug connection on intercom system switch.
Installation:
Following parts of trim (4) must not be damaged or missing:
- Front insert
- Retaining lugs
- Pins or spring clips
Replacement:
Remove front insert (1) .
Replacement with Security version:
Remove intercom system switch.