54 34 300 Removing and installing/replacing rear window
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove rear window module
- Remove seal for rear window
Unfasten screws.
Tightening torque 54 34 10AZ. See SLIDE/TILT SUNROOF AND CONVERTIBLE TOP - TIGHTENING TORQUES .
Slacken screws on left and right.
Tightening torque 54 34 11AZ. See SLIDE/TILT SUNROOF AND CONVERTIBLE TOP - TIGHTENING TORQUES .
Disconnect left and right plug connections (2).
Installation:
Adjust right grub screw to dimension A in relation to Hall sensor.
A = 1 mm
Calibrating rear window:
Rear window must be moved downwards (signal from Hall sensor - rear window at bottom).
This enables the convertible top module to determine the starting travel of the rear window travel sensor.
Check function.
WARNING:
Power window unit has no anti-trapping mechanism.