52 14 070 Removing and installing/replacing seat angle adjuster on left or right front seat (normal/electric)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, 2007 BMW X3, and 2006 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove front seat, see 52 14 000 Removing and installing left or right front seat (normal/electric)
- Remove outer cover, see 52 16 040 Removing and installing/replacing outer cover on front left or right seat (sports/electric)
Release screws (1).
Release screw (2).
Unclip carrier (3) from seat mechanism at rear.
Unlock plug connection (1) on drive unit (2) and disconnect.
Release screws (1).
Installation:
Replace Taptite screws (1).
Tightening torque: 52 10 16AZ, see 52 10 FRONT SEATS .
Release screw (2).
Tightening torque: 52 10 17AZ, see 52 10 FRONT SEATS .
Remove seat angle adjuster (3).
Installation:
Slide left and right O-rings onto shaft. Make sure O-rings are correctly located between seat angle adjuster and seat pan.