51 47 440 Removing and installing/replacing rear carpet on seat pan
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove left/right front seat . See SEATS - REPAIR .
- Remove handbrake lever . See 34 41 000 REMOVING AND INSTALLING / REPLACING HANDBRAKE LEVER .
- Remove vehicle centre sensor . See 65 77 730 REMOVING AND INSTALLING (REPLACING) VEHICLE CENTRE SENSOR .
- Remove rear left/right side trim .
- Remove front inside entrance cover strip .
Disconnect connector (1).
Lay cable (2) back.
Feed out cables (3 and 4) through carpet (5).
Remove carpet (5).
Installation:
Make sure openings for air duct and attachment points are correctly positioned.
Make sure all cables are in correct position.