51 47 000 Removing and installing/replacing front (inside) left or right entrance cover strip

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Risk of breakage to connecting lug on B-pillar trim panel. Do not raise entrance cover strip (1) over entire length simultaneously.

Detach entrance cover strip (1) at clips (2) from front to rear.

Detach entrance cover strip (1) from B-pillar trim panel at bottom in direction of arrow.

If necessary, lever out clips from floor plate.

Fig 1: Detaching Entrance Cover Strip From Front

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Fit entrance cover strip (2) with preinstalled clips (1).

If necessary, replace faulty clips (1).

Connecting lug (3) of entrance cover strip (2) must not be damaged.

Fig 2: Identifying Cover Strip, Clips And Lugs

Courtesy of BMW OF NORTH AMERICA, INC.