63 12 015 Removing and installing/replacing left headlight (adaptive headlight)
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Version with xenon headlights: Danger to life due to high voltage! Therefore, before removing, disconnect all components from the power supply (lighting system and ignition off).
Work on the entire xenon lighting system (control unit, ignition unit with bulb) may only be carried out by specialist personnel.
Follow instructions for Handling Light Bulbs (Exterior Lights).
IMPORTANT:
Read and comply with Notes On Protection Against Electrostatic Damage (ESD Protection).
Necessary preliminary tasks:
- Remove Front Bumper Trim
Unlock catches (1) in direction of arrow and remove high-pressure nozzle (2) towards rear out of headlight arm (3).
Release screw (1) on headlight arm (2) (from wheel arch side).
For tightening torque refer to 63 12 1AZ in 63 12 HEADLIGHTS .
Release screws (1). For tightening torque refer to 63 12 3AZ in 63 12 HEADLIGHTS .
Installation:
- Observe 41 00... BODY GAP DIMENSIONS .
- Adjust Headlights
If necessary, unclip electric lead (2) from headlight arm.
Pull out headlight (3) slightly and unlock and disconnect associated plug connection.
Remove headlight (3) towards front.
Replacement:
- Release screws (1) and remove headlight arm (2) from headlight.
- Remove Ignition Unit With Bulb For Xenon Headlight
- Remove Control Unit For Xenon Headlights
- Remove Drive Unit For Adaptive Headlight
- If necessary, remove Bulbs.