51 11 156 Removing and installing front bumper trim

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Version with headlight washer system:

Remove Cover For Headlight Washer System on left/right

Release screws (1) on bumper trim (2).

Fig 1: Retaining Screws And Bumper Trim

G04752443

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on wheel arch trim (2) on left and right.

Lift out wheel arch trim (2) at side.

Installation:

Make sure wheel arch trim (2) is in correct position.

Fig 2: Screws And Wheel Arch Trim

G04752444

Courtesy of BMW OF NORTH AMERICA, INC.

Press wheel arch cover (1) to one side.

Release left and right screws (2).

Fig 3: Wheel Arch Cover And Retaining Screws

G04752445

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on bumper trim (2).

Fig 4: Screws And Bumper Trim

G04752446

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Do not damage bumper trim when pulling off.

Detach bumper trim (1) at sides.

Pull bumper trim (1) forwards slightly and if necessary disconnect plug connections on ultrasonic sensors and/or fog lights.

Remove bumper trim (1) towards front with aid of a 2nd person.

Installation:

Height adjustment, refer to 41 00... BODY GAP DIMENSIONS .

Fig 5: Bumper Trim And Removal Directions

G04752447

Courtesy of BMW OF NORTH AMERICA, INC.